Service manual

Revision D B-3
Appendix B: Technical Description : Technical Specifications
Series 2000 Treadmill
409110-004
Technical Specifications
Table B-1. Performance Specifications
Item Specification
Maximum Rated Load 182 kg (450 lbs)
Drive Motor 3.0 HP, brushless, DC motor
Elevation Motor 0.13 HP
Belt Speed Range 0.0 to 22.5 km/h (0 to 13.5 mph) at 220V, @ 50/60 Hz continuously variable, zero
mph start-up
Belt Speed Tolerance ±0.16km/h ( ± 0.1mph)
Belt Speed Acceleration/Deceleration Approximately 0.8 km/sec (0.5 mph/sec)
Elevation Range 0.0 to 25.0% grade, continuously variable
Elevation Range Increase/Decrease 1.14%/sec. @ 60 Hz
Manual Treadmill Controller (Optional) Functions: On, Off, Up, Down, Fast, Slow, Automatic Protocol Selection, Elapsed
Time, Distance Traveled
Automatic Protocols: 15 exercise and 15 rehabilitation (includes Bruce, Naughton,
Balke II, Ellestad, Low Performance)
Maximum Leakage Current 100 µA, chassis to ground
Interface Either RS-232 port or RS-422 serial port, 9600 baud
Mode of Operation Continuous
Degree of protection against ingress
of water
Ordinary
Table B-2. Physical Specifications
Item Specification
Weight 181.4 kg (400 lb)
Walking Area 45.7 cm x 152.4 cm (18 in x 60 in)
Floor Space Required 73.7 cm x 195.6 cm (29 in x 77 in)
Walking Surface Height 14.0 cm (5.5 in)
Handrail Height Above Walking
Surface
Front: 101.6 cm (40 in)
Side: Maximum 88.9 cm (35 in) descending at 5° angle to 81.3 cm (32 in)
Table B-3. Power/Environmental Specifications
Item Specification
Power Requirements 200 to 265 VAC, 60 Hz, single phase, 20 A, NEMA 6-20 R wall socket (dedicated
circuit recommended)
Power Consumption 1540 watts, 16 A