Owner`s manual

fi_qq:}_'}i[qqlhv{,
Problem
The sound suddenly
goes off.
Only the speaker on
one side can be
heard.
Only the center
speaker outputs
substantial sound,
No sound from the
effect speakers.
No sound from the
center speaker,
No sound from the
surround speakers.
No sound from the
surround back
speakers.
No sound from the
subwoofer.
Refer to
Cause Remedy
page
The protection circuitry has been activated Check that the impedance selector setting is correct. 73
because of a short circuit, etc.
Check that the speaker wires are not touching each
other and then turn this unit back on.
The sleep timer has turned the unit off. Turn on the power, and play the source again.
The sound is muted. Press MUTE to cancel a mute.
Incorrect cable connections.
Connect the cables properly. If the problem persists,
the cables may be del_:ctive.
Incorrect balance settings in SET MENU.
When playing i monaural source with a
CINEMA DSP program, the source signal
is directed to the center channel, and the
front md surround speakers output effect
sounds.
31
12
Adjust Ihe SPEAKER LEVEL settings. 65
The sound field programs are turned off. Press STRAIGHT (EFFECT) to turn Ihem oil.
You are using a source or program Try another sound field program.
combination Ihat does not output sound
from all channels.
The output level of the center speaker is Raise the level of the center speaker.
set to minimunL
"CENTER SP" in SET MENU is set to Select the appropriate setting for the center speaker.
NONE.
One of the HiFi DSP programs (except for Try anolher sound field program.
7ch Stereo) has been selected.
The output level of the surround speakers Raise the output level of the surround speakers.
is set to [IlinilIl/lllL
"SUR. L/R SP" in SET MENU is setto
NONE.
Select the appropriate setting for the surround left and
right speakers.
Press STRAIGHT (EFFECT) to turn on the sound
fields.
A monaural source is being played with
STRAIGHT.
Surround back speakers arc not selected. Select surround back speakers in SUR. B L_ SP.
"SUR. L/R SP" in SET MENU is setto
NONE.
If file surround left and right speakers are set to
NONE, the surround back speaker setting is
automatically set to NONE. Select the appropriate
setting for the surround speakers.
Select LRGxl or SMLxl."SUR. B L_ SP" in SET MENU is set to
NONE.
Select SWFR or BOTH.
Select BOTH.
"LFE/BASS OUT" in SET MENU is set
to FRNT when a Dolhy Digital or DTS
signal is being played.
"LFE/BASS OUT" in SET MENU is set
to SWFR or FRNT when a2-channel
source is being played.
The source does not contain low bass
signals.
36
55
65
63
55
65
63
64
63
64
64
64
89