Owner`s manual

• DIALG.LIFT (Dialog lift)

Function: Adjnsts tile height of tile front and center channel sounds by assigning some of the front and center

channel elements to the presence speakers.

Description: The larger the parameter, the higher the position of the front and center channel sound.

Choices: 0/1/2/3/4/5, initial setting is 0.

For 2ch Stereo:

• DIRECT (Direct)

Fnnction: Bypasses this unit's decoders and DSP processors for pure high fidelity sound when playing 2-channel

analog sources. The AUTO setting is effective only when BASS and TREBLE are set to 0 dB.

Choices: AUTO, OFF

• When multi-channel signals/Dolby Digital and DTS) are input, they are downmixed to 2 channels and output from the front left and

right speakers.

• When "BASS OUT" is set to BOTH, or "FRONT SP" set to SMALL and "BASS OUT" set to SWFR, front left and right speaker low-

frequency signals are redirected to the subwoofer.

For 7ch Stereo:

Function: These parameters adjnst tile volume level for each channel in 7-channel stereo mode.

Control Range: 0- 100%

• CT LEVEL (Center level)

• SL LEVEL (Surround left level)

• SR LEVEL (Surround right level)

• SB LEVEL (Surround back level)

• PL LEVEL (Presence left level)

• PR LEVEL (Presence right level)

For PRO LOGIC IIx Music and PRO LOGIC II Music:

• PANORAMA (Panorama)

Function: Sends stereo signals to tile surround speakers as "a,ell as tile front speakers for a "a,raparonnd effect.

Choices: OFF, ON

• DIMENSION (Dimension)

Function: Gradually adjusts the sound field either towards the front or towards the rear.

Control range: 3 (towards the rear) to +3 (towards the front), initial setting is STD (standard).

• CENTER WIDTH (Center width)

Fnnction: Adjusts the center image from all three front speakers to varying degrees. A htrger value adjusts tile

center image towards the front left and right speakers.

Control range: 0 (center channel sound is output only from center speaker) to 7 (center channel sound is output only

from front left and right speakers)

Initial setting: 3

Note

This parameter can be set only when SUR. STANDARD is selected.