Owner`s manual

II:le]ilhT[ei_'_o]lhqel_l:lllpl'.]:T:y:Ti_l:ll:l:_:

4 Press A / v to select

the parameters.

PRE_ET/C_

• Resetting parameters to the factory

presets

Use PARAM. IN] (see page 71).

Press ( / ) to change

the parameter value.

When you set a parameter

to a value other than the

factory-set value, an

asterisk mark (*) appears

by the parameter name on

the on-screen display.

If you press and hohl ( / ) to changetile parameter value, tile

front panel display automaticallystops at the factory preset

paran/eter ii/(lll]et]tly.

0 Repeat steps 3 through 5 as necessary to

change other program parameters.

ato

Youcannot changeparameter values when "MEMORYGUARD"

is set to ON. If you want to change the parameter values, set

"MEMORY GUARD" to OFF/see page 70).

Memory back-up

The memory back-up circuit prevents the stored data

from being lost even if this unit is set in the standby

mode, the power cord is disconnected from the AC

outlet, or the power supply is temporarily cut due to

power failure. However, if the power is cut for more

than one week, the parameter values will return to the

factory settings. If this happens, edit the parameter

value again.