Owner`s manual

The remote control returns to tile main mode 10 seconds after you
press _:,-_>,or if you press any button other than SYSTEM
POWER, STANDBY, MUTE, VOLUME +_ or tile input
selector buttons. If the TRANSMIT indicator is turned off, press
,;'_/_to set tile remote control to Zone 2 mode before turning Zone
2 power on or off, changing tile input source, or muting the sound.
• To control the power of the main unit
and Zone 2 unit
To turn all units (the main unit and Zone 2 unit) to
standby:
While hokting down AMP, press STANDBY.
To turn on all units (the main unit and Zone 2
unit):
While hoktiug do'an AMP, press SYSTEM POWER.
_.,#._
STANDBY and SYSTEM POWER work differently depending
on tile selected mode.
TRANSMIT
Mode
indicator
Main mode
Zol[e 2 mode
off
O[/
STANDBY/
SYSTEM POWER
Press STANDBY to turn
the main unit to standby.
Press SYSTEM POWER
to turn on the main unit.
Press STANDBY to turn
the Zone 2 component to
standby.
Press SYSTEM POWER
to turn on the Zone 2
cOtllponent.
• Special considerations for DTS software
The DTS signal is a digital bitstream. If you attempt to
send the DTS signal to the second room you will only hear
digital noise (that may damage your speakers). Thus, the
following considerations and adjustments need to be made
when playing DTS-encoded discs.
For DVDs encoded in DTS
Only 2 channel analog audio signals may be sent to the
second roolll,
Use the disc menu to set the DVD player's mixed
2-channel left and right audio outputs to the PCM or
Dolby Digital soundtrack.
For CDs encoded in DTS
To avoid unexpected noise, DO NOT USE the Zone 2
feature with CDs encoded in DTS.
80