Owner`s manual

Using this unit's internal amplifier
To use this unit's internal amplifier, set "ZONE2 AMP" to INT in the SET MENU (see pages 71).
This unit
The supplied remote control can be used to control Zone
2. You can even select the input source and control
components located in the main wont directly from the
second room regardless of the listening condition in the
nlain rooln,
You cart also turn on/off tile main or Zone 2 mode by pressing
MAIN or ZONE 2 on tile Kont panel.
• To enable Zone 2 mode on the remote
control
1 Press _.>.
1
To control Zone 2
Press _<_ to set the remote control to Zone 2.
The TRANSMIT indicator on the remote control
lights lip while the remote control is in Zone 2 mode.
2 Press SYSTEM POWER to turn Zone 2 power
on.
3 Press an input selector button to select the
input source you want to listen to in the
second room.
Press CODE SET using a ballpoint pen or
similar object.
The TRANSMIT indicator on the remote control
flashes twice.
Enter the code number "2999".
Immediately after you have configured the remote
control for Zone 2, the remote will enter main mode.
When the remote is in main mode, you can turn the
main unit on, or set it in standby mode independently
of Zone 2 by pressing SYSTEM POWER or
STANDBY.
• If you enable Zone 2. tile Zone fimction is applied to the current
remote control ID (IDI: defmllt code. ID2: alternalive code).
However. because tile remote control codes for Zone 2 are
common to ID 1 and ID2. the remote control ID does not change
even if it is switched.
• To release Zone 2. clear the remote control code set l\_r/':/_, or
set a remote control code other than a TV code for ,/,i\-.
4 You can control Zone 2 using the input
selector buttons, STANDBY, SYSTEM
POWER, MUTE and VOLUME +/-.
If "ZONE2 AMP" in OPTION MENU is set to INT. you can use
VOLUME /+ to a_ljust sound output from speakers connected to
the PRESENCE/ZONE 2 speaker terminals. However. VOLUME
/+ cannot be used to adjust sound output from the ZONE2
OUTPUT jacks.
79