Owner`s manual

You can select the unit you want to operate with the
remote control by entering the library code.
./:/j_[o]l:lgol_Til:{olll::Y_|ll]:/-_- -
Press CODE SET using a ballpoint pen or
similar object.
The TRANSMIT indicator on the remote control
flashes twice.
Press an input selector button or ¢:_ to
select the component control for which you
want to clear the remote control code.
2 Enter the code number "9991" or "9992" (see
the table below).
The TRANSMIT indicator on the remote control
flashes twice, and the library code is changed.
AMP library Remote
code
control ID (unit
(remote Function
control setting: see
setting) page 73)
9991 To operate this unit IDI
using the defaull code. (inilial selling)
To operate this unit
9992 using an ahernative ID2
code.
When using multiple YAMAHA receivers/amplifiers, you
may be able to operate the other components simultaneuusly
with the default code setting. 111this case, set one of the
alternative codes to operate this unit separately.
Press CODE SET using a ballpoint pen or
similar object.
The TRANSMIT indicator on the remote control
flashes twice.
3 Enter the code number"0000".
The TRANSMIT indicator on the remote control
flashes twice, and the remote control code for the
selected component is cleared.
-#.
• If you do not press any button within 30 seconds after step 2,
the clearing process is canceled. If this happens, start over from
step 1.
• You can clear all setup remote control codes at once by entering
the code number "9990".
S oS
You must also m_ke e ine lot he recelver/a uplifier.
77