Owner`s manual

• Downmixing to 2 channels
You can enjoy 2-channel stereo playback even frona nmlti-
channel sources.
Rotate PROGRAM (or press AMP to select the
AMP mode, then press STEREO on the remote
control) to select 2ch Stereo.
PF_OG RAr_'I
STEREO
or _ %
Front panel Remote control
2ch Si.:.ei..eo
Youcanuse a subwoofer with this program when SWFR or
BOTH is selected in "BASS OUT".
• Listening to unprocessed input signals
In STRAIGHT mode, two channel stereo sources are
output from only the front left and right speakers. Multi-
channel sources are decoded straight into the appropriate
channels without any additional effect processing.
Press STRAIGHT (or press AMP to select the
AMP mode, then press STRAIGHT on the remote
control) to select STRAIGHT.
STRAIGHT
STRAIGHT
or
EFFECT
Front panel Remote control
t"""i";""H""_'i"t"".t;'T'
",lm'h.lll"H'll
Press STRAIGHT (EFFECT) again so that "STRAIGHT"
disappears from the display when you want to turn the
sound effect back on.
• Virtual CINEMA DSP
Virtual CINEMA DSP allows you to enjoy the CINEMA
DSP programs without surround speakers. It creates
virtual speakers to reproduce the natural sound field.
If you set "SUR. L/R SP" to NONE (see page 63), Virtual
CINEMA DSP activates automatically whenever you
select a CINEMA DSP sound field program.
Note
Virtual CINEMA DSP will 11(!1aclivale, exen when "SUR. L/R
SP" is sel to NONE (see page 63) in Ihe following cases:
When MULTI CH INPUT is selected as Ihe input source.
When headphones are connecled lo the PHONES .jack.
This unit comes with a variety of input.jacks. Do the
follovving to select the type of input signals you want to
use.
1
Rotate INPUT to select the input source.
INPUT
Front panel
2 Press INPUT MODE to select an input mode.
In most cases, use AUTO.
Front panel
Input source
l::ii.JTCl Automatically selects input signals in
the following order:
1) Digital signals*
2) Analog signals
l)"i":!!!; Selects only digital signals encoded in
DTS. If no DTS signals are input, no
sound is output.
]:il"4{:::]i....ll)li!) Selects only analog signals. If no
analog signals are input, no sound is
output.
':' If this unit detects a DolbyDigital or DTS signal, the
decoder automatically switches to the appropriate
decoder.
-#-
Youcan adjust the default input mode of this unit (see page 69).
36