Owner`s manual

INqI'M=PtlPh'_

• Connecting to an external amplifier

If you "a,ant to increase tile power output to the speakers,

or want to use another amplifier, connect an external

amplifier to the PRE OUT jacks as follows.

• When audio pin plugs are connected to the PRE OUT jacks for

output to an external amplifier, do not make connections to the

corresponding SPEAKERS terminals. Set the volume of the

amplifier connected to this unit to the maximum.

• The signals output through the FRONT PRE OUT and

(-?ENTER PRE OUT jacks are affected by the TONE

CONTROL settings.

• If SPEAKERS A is turned off and SP B is set to ZONE B (see

page 711, signals will only be output [nnn the FRONT PRE

OUT jacks.

O FRONT PRE OUT jacks

Front channel line output jacks.

O SURROUND PRE OUT jacks

Surround channel line output jacks.

O CENTER PRE OUTjack

Center channel line output jack,

• SURROUND BACK PRE OUT jacks

SurromM back or presence channel line output jacks.

O SUBWOOFER PRE OUT jack

Comlect a subwoofer "a,ith built-in amplifier, such as the

YAMAHA Active Servo Processing Subwoofer System,

to this jack.

• Each PRE OUT.jack outputs the same channel signals as the

corresponding speaker terminals.

• A;ljust the volume level of the subwuofcr with the control on

the subwoofer. It is also possible to atljust the volume level

using the remote control (see "Malmally a_[justing speaker

levels" on page 59).

• Some signals may not be output from the SUBWOOFER PRE

OUT.jack depending uu the SPEAKER SET/see page 63) and

LFE/BASS OUT (see page 64) settings.