User Manual

E34
Watching TV
Selecting the channels
This monitor allows you to select up to 100
channels (0-99).
MAIN
POWER
CH
MENU
INPUT
PC AV2AV1TV
BRIGHT
MODE
BRIGHT
CH
POWER
SLEEP MENU
DISPLAY
FREEZE
/HOLD
SOUND
SUBPAGE SUBTITLE
VIEW MODE
TEXT REVEAL
PIP
OK
/BRIGHT
OK
/
BRIGHT
MODE
Using the channel buttons (remote control)
To select a 1-digit channel number (e.g., Channel 5):
Select the channel number using one of the
following procedures.
- Press the 5 button and wait for approximately
3 seconds.
- Press the 0 button followed by the 5 button
within 3 seconds.
To select a 2-digit channel number (e.g., Channel 12):
Press the 1 button followed by the 2 button within
3 seconds.
Using the buttons (monitor/remote control)
- Press the
button and the channel changes in
the order shown below:
1 → 2 … → 98 → 99 → 0 → 1 → 2 → …
- Press the
button and the channel changes in
the order shown below:
2 → 1 → 0 → 99 → 98 … → 2 → 1 → 0 → …
Notes:
- Pressing one of the above buttons or using the
programme table (see right column)
automatically switches to TV mode if the monitor
is in PC or AV mode.
- Use the INPUT button (monitor) or the TV button
(remote control) to switch the display mode to TV
in the following cases when in PC mode.
- When you are watching TV in the PIP window
(see page E20).
- When you are listening to TV (see page E21).
- Channels set to be skipped cannot be displayed
using the
buttons. (See page E31.)
- Channel “0” is reserved for RF output from a
VCR.
Selecting the channels using the
programme table
The programme table shows a list of programmes
in TV memory. They are located in channels 0 to
99. The currently selected programme is displayed
in yellow and child-locked programmes which
have not been cancelled are displayed in red.
1.Select the TV mode using the INPUT button
(monitor) or the TV button (remote control).
2.Press the OK button (remote control).
The programme table will be displayed.
Note:
- While the Teletext screen or the menu screen
is being displayed, you can not display the
programme table by pressing the OK button
(remote control).
PROGRAMME TABLE < TV/AV >
00 05 10 15
01 E02 06 11 16
02 E03 07 12 17
03 E04 08 13 18
04 09 14 19
3.Select the desired programme using the
buttons (remote control).
To display the previous or next list of the
programme table:
- Press the
buttons (remote control) when
the cursor is at a programme in the upper-left
or low-right position.
- Press the
buttons (remote control) when
the cursor is at a programme in the left or right
column.
4.Display the selected programme using the OK
button (remote control).