Installation Manual RESU 7H DLT Type-C

25
Installation
CAUTION
Please must do the switch on & o operation at the middle side of SHT31 and
Ex9BP combined. It's forbidden to do the operation at the left or right edge side of
combined body. Any wrong operation cause the products break o.
14. Reattach the transparent protection
cover and tighten with the screw
(Marked position)
Close the wiring box cover. Reattach
battery over the two latchets on the
rear.
※ Connect/disconnect the wire to connector sequence
1. To remove one of the wires from its
terminal, insert a small screwdriver
into the rectangular hall above the
terminal.
2. Apply slight pressure to the
screwdriver and at the same time pull
out the wire.