Installation Manual RESU 7H DLT Type-C

23
Installation
Transparent protection cover
7. Loosen the screw (marked position),
and remove the transparent
protection cover.
power cable
connector
8. Assemble power cable connector after
removing protection cover.
CAUTION
Check circuit breaker switch o
before connecting power cable
connector.
9. Remove the cap on hole in the bottom
side, and assemble the ¾" conduit
plug. In the case outdoor, it must be
sealed to comply “IP55” [ex) gasket,
sealing foam, silicon, etc], where the
battery pack installation is outdoor.