Installation Manual
Table Of Contents
- 1 Introduction
- 2 Safety
- 3 Installation
- 4 Troubleshooting
- 5 Emergency Situations
- 6 Warranty
- A Technical Information
Installation
Voltage
Measure the voltage at the terminal block using a voltmeter.
1. Make sure that the circuit breaker
switch is put in the Trip position, and
then measure the voltage. If the volt-
age is higher than 0 V, contact LG
Chem or your distributor.
2. Move the circuit breaker switch to the
ON position, and then measure the
voltage. If the voltage is lower than
36 V, contact LG Chem or your distrib-
utor.
30