Installation Manual

Installation
5. Fasten the connecting bracket to the
main pack.
a) Loosen the M4 screw on the top
left.
b) Insert the connecting bracket
through the left grommet.
c) Hold the bracket in place and
tighten the screw in the left hole of
the bracket to a torque of 2 N·m.
6. Loosen the screw in the corresponding
position of the expansion pack.
NOTE
When connecting an expansion pack to
another one, use the right hole of the
connecting bracket.
7. Insert the cables coming from the
expansion pack into the main pack
through the grommets.
24