Installation Manual
Table Of Contents
- 1 Introduction
- 2 Safety
- 3 Installation
- 4 Troubleshooting
- 5 Emergency Situations
- 6 Warranty
- A Technical Information
Installation
NOTE
If an expansion battery pack should be installed, leave the right side un-
fastened. Secure the right side of the expansion pack to the wall after the
expansion pack is fully installed.
Connecting the battery pack to the inverter
CAUTION
Make sure that the inverter is turned o before connecting the battery pack
to the inverter.
To connect the cables coming from the inverter to the battery pack, take the
following steps:
Status
Charge / Discharge
RESU 6.4
R
1. Remove the top cover. Hold both sides
of the top cover and pull it upwards.
2. Remove the protective tape that covers
the circuit breaker switch.
18