Installation Manual RESU 13
Table Of Contents
- About this manual
- 1 Safety
- 2 Product Introduction
- 3 Installation Prerequisites
- 4 Battery Pack Installation
- 5 RESU Plus Installation
- 6 Configuration Switches
- 7 Commissioning
- 8 Troubleshooting
- 9 Firmware Update
- 10 Warranty
- 11 Certifications
- A Compatible Inverters
- B Supported Memory Cards
8
1.3.1 Leakingbatteries
If the battery pack leaks electrolyte, avoid contact with the leaking liquid or gas.
Electrolyte is corrosive and contact may cause skin irritation and chemical burns.
If one is exposed to the leaked substance, do these actions:
Inhalation : Evacuate the contaminated area, and seek medical attention immediately.
Eye contact : Rinse eyes with owing water for 15 minutes, and seek medical attention
immediately.
Skin contact : Wash the affected area thoroughly with soap and water, and seek medical
attention immediately.
Ingestion: Induce vomiting, and seek medical attention immediately.
1.3.2 Fire
In case of a re, make sure that an ABC or carbon dioxide extinguisher is
nearby.
WARNING
The battery pack may catch re when heated above 150°C.
If a re breaks out where the battery pack is installed, do these actions:
1. Extinguish the re before the battery pack catches re.
2. If the battery pack has caught re, do not try to extinguish the re. Evacuate people
immediately.
WARNING
If the battery catches re, it will produce noxious and poisonous gases.
Do not approach.
1.3.3 Wet batteries
If the battery pack is wet or submerged in water, do not try to access it. Contact LG Chem or
your distributor for technical assistance.
Safety