Installation Manual RESU 13
Table Of Contents
- About this manual
- 1 Safety
- 2 Product Introduction
- 3 Installation Prerequisites
- 4 Battery Pack Installation
- 5 RESU Plus Installation
- 6 Configuration Switches
- 7 Commissioning
- 8 Troubleshooting
- 9 Firmware Update
- 10 Warranty
- 11 Certifications
- A Compatible Inverters
- B Supported Memory Cards
33
RESU Plus Installation
J4 J9
3. Connect each power cable to its corresponding
terminal block. Use the terminal block at the
left for the rst battery pack and the one at the
right for the second battery pack. Connect the
negative line (−) to the terminal on the left and
the positive line (+) to the one on the right.
4. Tighten the sealing nuts rmly.
5.4.4 Connectingnetworkcables
It is required for the battery packs to communicate with the inverter via the RESU Plus for
their proper operation.
J4 J9
1. Connect each network cable to its
corresponding network port. Use the port at the
lower left for the rst battery pack, the one at
the lower right for the second battery pack, and
the one at the upper for the inverter.
J4 J9
2. Apply silicone sealant or putty around the
grommets and their slit.