Installation Manual RESU 13
Table Of Contents
- About this manual
- 1 Safety
- 2 Product Introduction
- 3 Installation Prerequisites
- 4 Battery Pack Installation
- 5 RESU Plus Installation
- 6 Configuration Switches
- 7 Commissioning
- 8 Troubleshooting
- 9 Firmware Update
- 10 Warranty
- 11 Certifications
- A Compatible Inverters
- B Supported Memory Cards
32
5.4.2 Connectinggroundwires
Grounding between the battery pack and the inverter is not mandatory but recommended.
1. Loosen the sealing nuts of the small glands that are closest to the edges.
2. Feed ground wires through the glands.
3. Connect each ground wire to its corresponding ground point. Use the ground point at the
lower left for the rst battery pack, the one at the lower right for the second battery pack,
and the one at the upper for the inverter.
4. Tighten the sealing nuts rmly.
5.4.3 Connectingpowercables
To supply power to the RESU Plus for its operation, connect the provided power cables from
the battery packs to the RESU Plus.
NOTE
Power cables must connect from both battery packs to ensure that the RESU Plus
operates normally even when either battery pack is off.
1. Loosen the sealing nuts of the small glands in
the middle.
2. Feed power cables through the glands.
RESU Plus Installation