Installation Manual RESU 13
Table Of Contents
- About this manual
- 1 Safety
- 2 Product Introduction
- 3 Installation Prerequisites
- 4 Battery Pack Installation
- 5 RESU Plus Installation
- 6 Configuration Switches
- 7 Commissioning
- 8 Troubleshooting
- 9 Firmware Update
- 10 Warranty
- 11 Certifications
- A Compatible Inverters
- B Supported Memory Cards
27
Battery Pack Installation
4.8 Finalizinginstallation
Follow these steps to nalize the installation.
1. Stuff the small grommets left unused with an insulating material like silicone sealant, and
then push them into the remaining holes.
2. Apply silicone sealant or putty around the cable at each grommet to prevent foreign
materials from entering the battery pack.
3. Check if the conguration switches are set properly, referring to ConguringBattery
packonpage35.
4. Turn on the battery pack as described in Commissioningbatterypackonpage39.
5. Replace the top cover and tighten the screws to a torque of 5 N·m.