Installation Manual RESU 13
Table Of Contents
- About this manual
- 1 Safety
- 2 Product Introduction
- 3 Installation Prerequisites
- 4 Battery Pack Installation
- 5 RESU Plus Installation
- 6 Configuration Switches
- 7 Commissioning
- 8 Troubleshooting
- 9 Firmware Update
- 10 Warranty
- 11 Certifications
- A Compatible Inverters
- B Supported Memory Cards
25
4.7.2 Connectingnetworkcable
It is required for the battery pack to communicate with the inverter for proper operation.
Connect a network cable between the battery pack and the inverter
1. The small grommet is too small for an RJ45
plug to pass through. Without RJ45 plug at the
end, feed the network cable through a small
grommet and then through the top of the small
cable entries.
2. Attach an RJ45 plug to the network cable using
a wire stripper and cable crimper. See Making
networkcableonpage17.
NOTE
Do not attach any boot to the network cable to keep the connector short.
Using a connector longer than 23 mm may prevent the top cover from
being reassembled properly.
3. Connect the network cable to the network port.
4. Push the grommet into the cable entry.
Battery Pack Installation