Installation Manual RESU 13
Table Of Contents
- About this manual
- 1 Safety
- 2 Product Introduction
- 3 Installation Prerequisites
- 4 Battery Pack Installation
- 5 RESU Plus Installation
- 6 Configuration Switches
- 7 Commissioning
- 8 Troubleshooting
- 9 Firmware Update
- 10 Warranty
- 11 Certifications
- A Compatible Inverters
- B Supported Memory Cards
24
Battery Pack Installation
6. There are screw holes for mounting brackets
on the top of the both sides of the battery pack.
Drive the M5 screws through the mounting
brackets into the holes and tighten them to a
torque of 5 N·m.
4.7 Cable connections
WARNING
Make sure that the inverter is turned off before connecting the battery pack to the inverter.
4.7.1 Environmentalrequirements
Grounding between the battery pack and the inverter is not mandatory but recommended.
1. Feed the ground wire from the inverter through a small grommet and then
through the bottom of the small cable entries.
2. Connect the ground wire to the ground screw, and tighten it to a torque of 4 N·m.
The screw type is M5.
3. Push the grommet into the cable entry.