Installation Manual RESU 13
Table Of Contents
- About this manual
- 1 Safety
- 2 Product Introduction
- 3 Installation Prerequisites
- 4 Battery Pack Installation
- 5 RESU Plus Installation
- 6 Configuration Switches
- 7 Commissioning
- 8 Troubleshooting
- 9 Firmware Update
- 10 Warranty
- 11 Certifications
- A Compatible Inverters
- B Supported Memory Cards
23
Battery Pack Installation
4.6 Securingbatterypacktowall
Secure the battery pack to a wall to prevent it from moving. If the battery pack is installed
above the oor or on a platform, make sure that the wall or platform is capable of supporting
the battery pack’s weight.
1. Determine where the mounting brackets are to
be placed using the drill template.
2. Drill holes in the wall for the M6 (0.25 in)
screw anchors. The drilling depth should be at
least 50 mm.
3. Drive the screw anchors through the mounting
brackets into the holes.
4. Tighten the screws to a torque of 5 N·m.
NOTE
It is allowed to use any other type of fastening suitable for the wall material.
5. Remove the top cover.