Installation Manual RESU 13
Table Of Contents
- About this manual
- 1 Safety
- 2 Product Introduction
- 3 Installation Prerequisites
- 4 Battery Pack Installation
- 5 RESU Plus Installation
- 6 Configuration Switches
- 7 Commissioning
- 8 Troubleshooting
- 9 Firmware Update
- 10 Warranty
- 11 Certifications
- A Compatible Inverters
- B Supported Memory Cards
16
Installation Prerequisites
3.3 Tools
These tools are required to install the battery pack.
14
14
14
Torque screwdriver Phillips-screwdriver bit Hex-key bit
14
14
14
Phillips-head screwdriver Flat-head screwdriver Torque wrench
14
14
14
Wire stripper Cable crimper Voltmeter
14
14
14
Tape measure Drill Sealant gun
Use properly insulated tools to prevent accidental electric shock or short circuits.
Use adjustable tools and measuring instruments that are certied for precision and accuracy.
3.4 Safetygear
Wear the following safety gear when dealing with the battery pack. Installers must meet the
relevant requirements onternational standards, such as IEC 60364 or the domestic legislation.
Insulated gloves Safety goggles Safety shoes