RESU 3.3, 6.5, 10, RESU Plus
Table Of Contents
- Contents
- 1 Safety
- 2 Product Introduction
- 3 Installation Prerequisites
- 4 Battery Pack Installation
- 5 RESU Plus Installation
- 6 Configuration Switches
- 7 Commissioning
- 8 Troubleshooting
- 9 Firmware Update
- 10 Warranty
- 11 Certifications
- A Compatible Inverters
- B Supported Memory Cards
RESU Plus Installation
J4 J9
3. Connect each power cable to its correspond-
ing terminal block. Use the terminal block at
the left for the rst battery pack and the one
at the right for the second battery pack. Con-
nect the negative line (−) to the terminal on
the left and the positive line (+) to the one on
the right.
4. Tighten the sealing nuts rmly.
5.4.4 Connecting network cables
It is required for the battery packs to communicate with the inverter via the RESU Plus
for their proper operation.
1. Connect each network cable to its correspond-
ing network port. Use the port at the lower left
for the rst battery pack, the one at the lower
right for the second battery pack, and the one
at the upper for the inverter.
2. Apply silicone sealant or putty around the
grommets and their slit.
37