Operation Manual

Attaching the stand unit
• Before attaching (or detaching) the stand, unplug the AC cord from the AC INPUT terminal.
• Before performing work spread cushioning over the base area to lay the TV on. This will prevent it from being damaged.
CAUTION
• Attach the stand in the correct direction.
• Be sure to follow the instructions. Incorrect installation of the stand may result in the TV falling over.
1 Insert the stand into the openings on the
bottom of the TV. (Hold the stand so it will
not drop from the edge of the base area.)
2 Insert and tighten the 4 long screws into the
4 holes on the rear of the TV.
3
2
3
1
1
22
1
Confirm that there are 10 screws (6 short
screws and 4 long screws) with the stand unit.
1
Detaching the stand unit
Repeat steps as explained in Attaching the
stand unit in reverse order.
Attach the stand hole covers.
(Align the tabs of the covers with the holes on
the TV, and press until they lock into place.)
1
2
Preparation
Attach the supporting post for the stand unit
onto the base using the box for the stand as
shown.
2
Removing the terminal cover
Before making any connections, remove the
protective adhesive tape from the cover.
Then press down on the upper hooks and
remove the rear terminal cover towards you.
4
Hex key
Short screw
Long screw
Hex key
Soft
cushion
LC-52HD1E-gb.indd 4LC-52HD1E-gb.indd 4 2008/03/24 15:00:332008/03/24 15:00:33