Operation Manual
Conditional Access Module (CI
Module)
In order to receive coded digital stations, a Conditional
Access Module (CI Module) and a CA Card must be
inserted in the CI slot of your TV set. (Page 6)
The CI Module and the CA Card are not supplied
accessories. They are usually available from your
dealer.
Inserting the CA Card into the CI Module
Make sure the TV set is switched off with the
main power switch (a) on the set, or pull the
AC plug.
With the side with the gold coloured contact
chip facing the side of the CI Module marked
with the provider’s logo, push the CA Card
into the CI Module as far as it will go. Note the
direction of the arrow printed on the CA Card.
Inserting the CI Module in the CI slot
Remove the rear terminal cover.
Remove the CI slot cover.
Carefully insert the CI
Module in CI slot 1 or CI slot
2 with the contact side
forward.
The logo on the CI Module
must be facing outward,
from the rear of the TV. Do
not use excessive force.
Make sure the module is not
bent in the process.
If the CI Module is correctly installed, the eject
button protrudes a little further.
1
2
3
4
Watching DVB broadcasts
Switching on the TV set
After powering on with the new CI Module inserted,
a dialogue will appear. You must conduct a station
search.
Press OK to start the station wizard.
Check the recommended search routine
parameters and then start the search.
Replace the cover.
Checking CI Module information
NOTE
• Make sure that CI Module is properly inserted.
• This menu is only available for digital stations.
Press MENU and the TV menu screen displays.
Press c/d to select “Setup”, and then press b
to move down.
Press a/b to select “Miscellaneous”, and then
press b to move down.
Press c/d to select the CI Module you want to
check, and then press OK.
• The content of this menu depends on the provider of
the CI Module.
Removing the CI Module
• Switch off the TV set’s main power switch (a).
Remove the cover from the rear of
the set.
Press in the eject button on the
appropriate module slot, and the
module will release.
Remove the module from the set.
Replace the cover.
5
6
7
1
2
3
4
1
2
3
4
28
LC-52HD1E-gb.indd 28LC-52HD1E-gb.indd 28 2008/03/24 15:01:152008/03/24 15:01:15