Operating instructions

Using external equipment
Use the PC terminals to connect a PC.
• The PC input terminals are DDC1/2B_compatible.
• Refer to page 77 for a list of PC signals compatible with the System.
AVC System (front view)
--o
m
q
RGB cable
commercially available)
3.5 mm stereo minijack cable
sommercially available)
Signal names for 15-pin mini D-sub connecter
PC
Pin No. Signal name Pin No. Signal name Pin No, Signal name
R _) GND (Ground) @ Not connected
G (_ GND (Ground) @ SDA
B @ GNU (Ground) _3_ HD
(_ Not connected (_) + 5V _ VD
CSYNC (_ GNU (Ground) _5_ SCL
• Macintosh adaptor may be required for use for some Macintosh computers.
To view an image from a PC, select "PC" from the
"INPUT SOURCE" menu using INPUT on the remote
control unit or on the Display. (See page 50.)
When connecting to a PC, the correct input signal type
is automatically detected. If the PC image does not
come in clearly, you may need to set the Auto Sync.
adjustment on the "Auto Sync." in the "Setup" menu.
(See page 49.)
You only need to select the input source on the "INPUT
SOURCE" menu.
• Each time INPUT is pressed, the input source toggles.
_) -46