Manual

Preparation
Before detaching (or attaching) stand, unplug the AC cord from the AC input and the system cable from the
Display.
• Do not remove the stand from the Display unless using an optional wall mount bracket to mount it.
Before attaching/detaching stand
• Before performing work make sure to turn off the System.
• Before performing work spread cushioning over the base area to lay the Display on. This will prevent it from
being damaged.
f
1
Unfasten the four screws used to secure the
stand in place.
2
Detach the stand from the Display.
(Hold the stand so it will not drop from the edge of
the base area.)
J
• Do not remove the stand and speaker from the Display unless using an optional bracket to mount it.
• To attach the stand, perform the above steps in reverse order.
, Installing the Liquid Crystal Television requires special skill that should only be performed by qualified service
personnel. Customers should not attempt to do the work themselves. SHARP bears no responsibility for improper
mounting or mounting that results in accident or injury.
Using an optional bracket to mount the Display
• You can ask a qualified service personnel about using an optional AN-37AG2 bracket to mount the Display
to the wall.
• Carefully read the instructions that come with the bracket before beginning work.
Hanging on the wall
AN-37AG2 wall mount bracket. (See the bracket instructions
for details.)
Vertical mourlting Angular mountinc
About setting the Display angle
LC-37G4U
,, 'Youcan setthe Displayon the wall
up to 5 degrees forwardwhen the
speakers are attached and up to 20_
degrees forwardwhenthe
speakers are not attached. Do not _/
set the angle outsidethose ranges.
LC-32G4U
,, 'Youcan setthe Displayon the wall
up to 15 degreesforward when the
speakers are attached and up to 20
degrees forwardwhenthe
speakers are not attached. Do not
set the angle outsidethose ranges.