Manual

Problem
LISTINGS disappeared after a
power failure.
Some channel numbers in the TV
Guide On Screen are incorrect,
You have not received any local
program listings.
® A program you set to record did
not record,
Possible Solution
Yeu should begin to receive listings again within 24 hours,
Yeu can correct them/Jsing "Changing channel display" under SETUP.
Lislings usually appear within 24 hours after a successful Setup.
Check the connections between the TV, cable, antenna, and the G-LINK cable if
using a cable box.
Verify Setup information under "Changing system settings",
Make sure the cable box is on, if applicable.
® Review step 4 and step 5 of "Basic Initial Setup" on page 21,
Make sure your recorder is turned off before the recording begins.
® Make sure there is free space available for recording on the tape or recording
device.
Check the SCHEDULE menu and verify that the program is listed, before
recording begins.
® Check the placement of the G-LINK cable in front of your recorder.
® The TV did not tune to a program ® Check the SCHEDULE menu and verify that the program is listed,
you scheduled with the reminder ® If you have a cable box, check the G-LINK cable,
feature.
You set a program to "auto tune
TV" and it did not.
® You set a program with the "power
on TV" option and it did not.
,_ Check the SCHEDULE menu and verify that the program is listed as a Reminder.
Highlight the program under LISTINGS and do the following:
- Press MENU on the remote control,
- Use I_' to highlight "edit reminder", and press ENTER,
- Verify the "auto tune TV" option reads "yes".
The TV must be on at the scheduled time for "auto tune TV".
,_ Check the SCHEDULE menu and verify that the program is listed as a Reminder.
,_ Highlight the program under LISTINGS and do the following:
- Press MENU on the remote control,
- Use T to highlight "edit reminder", and press ENTER,
- Verify that the "power on TV" option reads "yes".
The 1_/must be off at the scheduled time for "power on TV",
(_ -92