Manual

QUmCK REFERENCE
TV GUIDE ON SCREEN TM QUmCK SETUP SHEET
Once you set up theTV according to this operat{on manual, you are ready to set upTV Guide On Screen!
Note: TV Guide On Screen TM interactive program guide supports cable-ready, cable box and digital cable
services as well as over-the-air broadcasL It does not provide listings for satellite services.
After completing the TV's initial setup, you see the TV
Guide On Screen Setup Welcome Screen,
Note: IfTV Guide On Screen is not setup, pressing TV
GUIDE while watching TV will display the Welcome
Screen,
Follow the on-screen instructions
If you previously skipped TV Guide On Screen setup,
you see the Reminder Screen,
Find theVCR and CabBe Box JR Sensors.
To control recording, find the VCR's IR sensor.
_) Turn the VCR off,
{2} Hold the VCR remote so that it touches the
front of tile VCR (Figure 1).
5} Move the remote across the front while
pressing POWER (Figure 2). (You must press
and release the power button each time you
move the remote; holding down the button will
not work).
_} When the VCR powers on, you have found
the sensor,
{5} Remember the location of the sensor, and go
to step 3,
mfyou have a cable box, repeat this procedure
using the cabme box and its remote, and then
go to step 3.
Figure 1
_ '................. ' _I
Correct Incorrect
Figure 2
Note: If you press ENTER and the screen does not
change, make sure that the batteries in the remote are
properly installed.
If you need to control a cable box and/or a VCR,
complete steps 1 through 3. If not, go to step 4.
Find and Connect the incBuded G-UNK cable
into the G-UNK terminal.
G-LINK cable with
Double-Sided -]_pe
G-LINK cable
Place the G-UNK cable(s)
To control a VCR, place one of the G-LINK
cables underneath the VCR approximately 1
inch in front of the sensor you found in step 2.
If you have a cable box, place the other G-
LINK cable approximately 1 inch in front of
the sensor you found in step 2.
Use the double-sided tape to secure each
G-LINK cable.
Tha end is connected to the TV as
Use theTV remote for On-Screen Setup
_ Press A/T/_/_ and ENTER to highlight an
item in a Setup screen.
_ Press ENTER to select that item.
ENTER
(_)-8