Service manual

8
LC-30HV6U
System cable
AVC System (rear view)
AC cord
Display (rear view)
Setting the System
After putting the Display and the AVC System in place, connect the system cables and AC cords. Use the
cable clamps for bundling the cables.
Preparation
Connecting the system cable and the AC cord to the Display
1
2
3
Removing the terminal cover
Connecting the system cable and the AC cord to the AVC System
CAUTION
• TO PREVENT RISK OF ELECTRIC SHOCK, DO NOT TOUCH UN-INSULATED PARTS OF ANY CABLES WITH THE
AC CORD CONNECTED.
Press down the four
upper hooks to remove
the cover toward you.
AC cord
(GRAY)
Connect the plug firmly until
the hooks on both sides click.
(WHITE)
Connect the plug into the
terminal and secure it by
tightening the thumb screws.
(BLACK)
Connect the plug completely.
(BLACK) (WHITE) (GRAY)
You cannot use external
speakers when you are using
the optional system cable
(AN-07SC1).
IMPORTANT
System cable
4
5
Attaching the clamps and bundling the cables with the clamp
Closing the terminal cover
Cable clamp (Large)
Insert the cable
clamp in the hole
on the Display leg
as shown.
Cable clamp (Small)
Peel off the seal
on the back and
attach as shown.
Display (rear view)
Cables come
out from the
small opening.
Arrange the system
cable as shown in
the illustration.