Service manual

LC-30HV6U

RS232C command table

Command

MSET1001

MOFR~~~~

MOFG~~~~

MOFB~~~~

MGAR~~~~

MGAG~~~~

MGAB~~~~

MINF0000

MINF0001

MINF0002

Function

Used to start the background adjustment.

Used to adjust the value of R OFFSET.

Used to adjust the value of G OFFSET.

Used to adjust the value of B OFFSET.

Used to adjust the value of R GAMMA.

Used to adjust the value of G GAMMA.

Used to adjust the value of B GAMMA.

Used to display the R GAMMA table.

Used to display the B GAMMA table.

Used to display the G GAMMA table.

Remarks

The adjustment ends with a numeric value other than 1001.

Range: 0000 to 0512 (Initial value: 0255)

Range: 0000 to 0255 (Initial value: 0100)

(1) Adjusting method using RS-232C

• Get a personal computer with a COM port (RS-232C) equipped with WINDOWS 95/98/me/2000/xp and

a RS-232C crossing cable

• Start up the set with the RS-232C cable connected.

• Start up the terminal software.

(Freeware products available on the Internet can be used.)

• Make setting as shown below.

Baud rate : 9600

Data : 8 bits

Parity : None

Stop : 1 bit

Flow control : None

• If the above setting is made correctly, pressing the "SET/ENTER" key on the PC will make "ERR" appear

on the terminal software.

• In this state, entering a command shown in the table bellow and pressing the "SET/ENTER" key will allow

you to make an adjustment.

If "OK" is displayed on the terminal software after the "SET/ENTER" key is pressed, the command has

been entered successfully.

If "ERR" is displayed, enter the command again.