Manual

Watchin TV
You can change channels in several ways by pressing
AIR or CABLE to select the antenna and then following
one of the methods below.
O
-- FAVORITE CH --
Method 1
Using CHA/V on the remote control unit or on the TV.
Method 4
1. Press INPUT.
2. Press A/T to select CableBox [TV], and then press
ENTER.
CableB0x [TV]
Method 2
1. Press FLASHBACK to switch to the previously tuned
channel.
2. Press FLASHBACK again to switch back to the
currently tuned channel.
3. Press CHA/V to change the channel of the cable
box.
• FLASHBACK will not work if no channel has been
changed after TV is turned on.
Method 3
Using remote control buttons (0-9, • (DOT) to select
channels for VHF/UHF/CATV/DIGITAL.
To select a 1 or 2=digit channel number
(e. g., Channel 5):
Press 5--> ENT
When selecting a 1-digit channel number, it is not
necessary to press 0 before the number.
When you enter 0-9 only, channel selection will be made
if there is no operation for a few seconds.
To select a 3=digit channel number
(e. g., Channel 115):
Press 1->1 ->5
-->
To select a 4=digit channel number
(e. g., Channel 22.1):
Press 2 ->2->, (DOT) ->1-> ENT
-34
When you enter 0-9 only, channel selection will be made
if there is no operation for a few seconds.
If you push "0" by itself, nothing will happen.
Complete the above steps within a few seconds.
When you enter 0-9 and • (DOT), channel selection will
be made if there is no operation for a few seconds.