Manual
Watching TV
You can change channels in several ways by pressing
AIR or CABLE to select the antenna and then following
one of the methods below.
AIR CABLE INPUT LAS4BAO_
@@O@
Method 1
Using CH/X/V on the remote control unit or on the TV.
Method 2
1. Press FLASHBACK to switch to the previously tuned
channel.
2. Press FLASHBACK again to switch back to the
currently tuned channel.
® FLASHBACK will not work if no channel has been
changed after TV is turned on.
Method 3
Using remote control buttons 0-9, ,, (DOT) to select
channels for VHF/UHF/CATV/DIGITAL.
To select a 1 or 2-digit channel number
(e. g., Channel 5):
Press 5--> ENT
® When selecting a 1-digit channel number, it is not
necessary to press 0 before the number.
® When you enter 0-9 only, channel selection will be made
if there is no operation for a few seconds.
To select a 3-digit channel number
(e. g., Channel 115):
Press 1->1->5
To select a 4-digit channel number
(e. g., Channel 22.1):
Press 2 ->2->= (DOT) ->1-> ENT
Q -16
® When you enter 0-9 only, channel selection will be made
if there is no operation for a few seconds.
® If you push "0" by itself, nothing will happen.
® Complete the above steps within a few seconds.
® When you enter 0-9 and * (DOT), channel selection will
be made if there is no operation for a few seconds.