Manual

Preparation
Use the remote control unit by pointing it towards the remote control sensor on
the TV. Objects between the remote control unit and the remote control sensor
may prevent proper operation.
•, Do not expose the remote control unit to shock. In addition, do not expose the
remote control unit to liquids, and do not place in an area with high humidity.
•, Do not install or place the remote control unit under direct sunlight.
The heat may cause deformation of the remote control unit.
•, The remote control unit may not work properly if the remote control sensor on
the TV is under direct sunlight or strong lighting. In such cases, change the
angle of the lighting or the TV, or operate the remote control unit closer to the
remote control sensor.
To enjoy a clearer picture, use an outdoor antenna. The following is a brief explanation of the types of connections
that are used for a coaxial cable. If your outdoor antenna uses a 75-ohm coaxial cable with an F-type connector,
plug it into the antenna terminal at the rear of the TV set.
1. A 75-ohm system is generally a round cable with F-type F-type connector
connector that can easily be attached to a terminal without Jr
tools (Commercially available).
2. A 300-ohm system is a flat "twin-lead" cable that can be
attached to a 75-ohm terminal through a 300/75-ohm
adapter (Commercially available).
75-ohm coaxial cable (round)
300-ohm twin-lead cable (flat)
F-type connector
75-ohm coaxial cable
F-type connector should be finger-tightened only.
When connecting the RF cable to the TV set, do not tighten
F-type connector with tools.
If tools are used, it may cause damage to your TV set.
(The breaking of internal circuit, etc.)
%.,.
Connecting Antenna Cable r_
0000000000000000000000000000000_00000000000000
Cable without a CATV _ _ Ill, Ill oII01111011110111011110111
converter .............. _ _[_
Combination m .___, _
VHF/UHFantenna
IIIIIIIIIIIIIIIIIIIIIo
DQDOQDQDOQDOOOQDOOOQD
or 75-ohm coaxial came rounr_) Coaxial cable I
ori 75 _ ( ................ '..... _X
i i
300"°Hm twin"lead (flat) (c°mme r¢lallY_ --available) L _1 __ \ .......................................................................h
Separate VHF/UHF
antenna V_E..AAmE,.A H ,,_'rr,_ ,,:: ...........,,1",
L 309-oHm twin-lead _.m | ',_1 ',_J
or
L... Depending on your reception
environment, either CABLE IN or
AIR IN may be used, or both
CABLE IN and AIR IN may be
used.
(_) -13