Specifications

12
Changing channels
You can select channels using 0 – 9 or CH a/b.
• To handle the increasing number of channels available, this LCD TV set allows you
to select up to 100 channels (0 to 99).
Using CH a/b
Press CH a and the channels change in the order shown below:
1 → 2 → 3 → . . . → 98 → 99 → 0 → 1 → 2 → 3 → . . .
Press CH b and the channels change in the order shown below:
3 → 2 → 1 → 0 → 99 → 98 → . . . → 3 → 2 → 1 → . . .
NOTE
• Channel “0” is reserved for RF output of VCR.
• Complete this procedure within 3 seconds, otherwise the selection will not be made on the 2-
digit channel mode.
Sound volume
To adjust the volume
|
Press
ii
ii
ik to increase the sound volume. The
bar indicator shifts right.
|
Press
ii
ii
il to decrease the sound volume. The
bar indicator shifts left.
To mute the sound
|
Press e (Mute) to temporarily turn off the sound.
“Sound off” is displayed.
|
Press e (Mute) to turn off the Mute function.
“Sound on” is displayed.
NOTE
• When i (k/l) is pressed in the Mute mode, the sound
turns on and the volume indicator is displayed.
• The Mute function is cancelled when POWER is pressed.
Sound off
Sound on
Volume
42
Volume
5
Using 0 – 9 on the remote control unit
Select the channels directly by pressing buttons 0 – 9.
a
To select a 1-digit channel (e.g. channel 2):
• Press 2. If “2” is indicated and the picture does not change, press o to switch over to the 1-digit
select mode and press 2 again.
To select a 2-digit channel (e.g. channel 12):
• Press o to set the 2-digit select mode. Press 1, followed by 2.
VOL
(l)/(k)
CH (s)/(r)
Basic operation
Control panel of the
main unit
Using Flashback (A) on the remote control unit
Press A to switch the currently tuned channel to the previously tuned channel.
Press A again to switch back to the currently tuned channel.
CHVOL
MENU MAIN POWER TV/VIDEO
lc22aa1h_en_p11_12 04.2.25, 2:55 PM12