Operation Manual

51
AV Connections (Continued)
[2] For programmes
• The influence of the AV control voltage and of fast blank at programme
positions from 1 to 199 can be set.
• When connecting a video device to the AV1 terminal, you need to adjust the
decoder programme settings.
Perform steps 1 and 2 in
[1] AV1/AV2/AV3 to display the “AV
connections” screen.
Press a/b to select “For programmes”,
and then press OK to display the “For
programmes” screen.
Press a/b to select the “AV control
voltage” or “RGB On-screen display.”.
Press c/d to select “yes” or “no”.
Press a/b to select “For decoder
connected to AV1”, and then press OK
to display the decoder programme
selection screen.
Press a/b and/or c/d to select the
programme for the decoder, and then
press OK. Repeat the same procedure if
you want to specify other decoder
programmes.
Press MENU to return to the “For
programmes” screen.
Press a/b to select “Sound from AV1”,
and then press c/d to select the
desired sound source.
Press END to exit.
OK
Back
R
End
E
For programmes
AV control voltage [ no]
RGB On-screen display [yes]
For decoder connected to AV1
Sound from AV1 [Dec.]
OK
Back
R
End
E
For programmes
AV control voltage [ no]
RGB On-screen display [yes]
For decoder connected to AV1
Sound from AV1 [Dec.]
OK
Back
R
End
E
AV connections
AV1
AV2
AV3(Y/C)
AV3(CVBS)
For programmes
OK
Back
R
End
E
For programmes
AV control voltage [ no]
RGB On-screen display [yes]
For decoder connected to AV1
Sound from AV1 [Dec.]
For decoder connected to AV1
OK
Back
R
End
E
0
1 E 02
2 E 04
3 U 02
4 U 04
5 E 05
6 E 08
7 E10
8
9
10
11
12
13
14
15
16
17
18
19
21
22
23
24
SHARP
ZDF
ARD
RTL
SAT1
Pro7
2
1
3
4
5
NOTE
• If the item concerned is set to “yes”, the appropriate
picture is through-connected at all programme positions
from 1 to 199 when a control voltage/an RGB signal is
applied.
6
7
8
9
Useful Features