Operation Manual

14
Changing channels
You can select channels using 0-9 or CH a/b.
• To handle the increasing number of channels available, this LCD TV set allows you
to select up to 200 channels (0 to 199).
Using CH a/b
Press CH a and the channels change in the order shown below:
1 → 2 → 3 → . . . → 198 → 199 → 0 → 1 → 2 → 3 → . . .
Press CH b and the channels change in the order shown below:
3 → 2 → 1 → 0 → 199 → 198 → . . . → 3 → 2 → 1 → . . .
NOTE
• Channel “0” is prepared for RF output of VCR.
• Complete this procedure within 3 seconds, otherwise the selection will not be made on the 2-
digit channel mode.
When viewing Teletext information
View a page directly which is 3-digit page number from 100 to 899 by pressing
buttons 0 to 9.
Sound volume
To adjust the volume
|
Press ik to increase the sound volume. The
numerical value increases.
|
Press il to decrease the sound volume. The
numerical value decreases.
To mute the sound
|
Press e (Mute) to temporarily turn off the sound.
“Sound off” is displayed.
|
Press e (Mute) to turn off the Mute function.
“Sound on” is displayed.
NOTE
• When Volume i (k/l) is pressed in the Mute mode,
the sound turns on and the volume indicator is displayed.
• The Mute function is cancelled when B is pressed.
Sound off
Sound on
Volume
50
Volume
10
Using 0 – 9 on the remote control unit
Select the channels directly by pressing buttons 0 to 9.
When selecting the channel using 0 to 9, finish inputting the channel number by
holding down the button for the last digit for a moment.
a
To select a 1-digit channel (e.g. channel 2):
• Press the 2 button.
To select a 2-digit channel (e.g. channel 12):
• Press 1, followed by 2.
• When you enter the channel, a 3-digit input underbar appears in digital TV mode
and a 2-digit in analogue TV mode.
Once you input a channel it is set after a few moments if there are no other
operations. Or press OK to set immediately after input.
Volume
(ik/l)
CH s/r
Basic operation