User Manual
11
Changing Channels
You can select channels using Channel Select or CH ( )/( ).
• To handle the increasing number of channels available, this LCD
TV set allows you to select up to 100 posi tions (Channels 0 to
99). One-digit and two-digit methods of selection can be used.
Follow the pro cedure shown below to select channels.
■
Using Channel Select
To select a one-digit channel (e.g., Channel 5):
Press 5 of Channel Select.
If “5–” is indicated and the picture does not change,
press -/-- to switch over to the 1-digit select mode
and press 5 of Channel Select.
3$/
%*
To select a two-digit channel (e.g., Channel 15):
Press -/-- to set the 2-digit select mode.
Press 1 of Channel Select.
Press 5 of Channel Select.
3$/
%*
NOTE
• Complete this procedure within 4 seconds, other wise the
selection will not be made.
Changing channels with CH (
)/( ) on the remote
control.
Press CH ( ) and the channels change in the order shown below:
1
→
2
→
3
→
. . .
→
98
→
99
→
0
→
1
→
2
→
3
→
. . .
Press CH ( ) and the channels change in the order shown below:
3
→
2
→
1
→
0
→
99
→
98
→
. . .
→
3
→
2
→
1
→
. . .
■
Using
A
(Flashback)
●
Press
A
to switch the currently tuned channel to the
previously tuned channel.
●
Press
A
again to switch back to the currently tuned
channel.
Sound Volume
■
To adjust the volume
●
Press VOL (+) to increase the sound volume.
The numerical value increases.
92/80(
0
●
Press VOL (–) to decrease the sound volume.
The numerical value decreases.
92/80(
0
■
To mute the sound
●
Press
(Mute) to temporarily turn off the sound. The
MUTE mark is displayed on the screen.
●
Press
(Mute) or VOL (+)/(–) to turn the sound back to
the previous level. MUTE is automatically cleared when
one of the following buttons is pressed: POWER,
VOL (+)/(–) or
(Mute).
92/80(
0
1
2
1
2
3
Basic Operation (Continued)
LC20B10NEP10-18.indd11LC20B10NEP10-18.indd11 2006/02/2010:45:312006/02/2010:45:31