Manual

[] Basic Connection
Thissectiondescribeshowto connecttee unit to an antenna, cane box,etc
Note:
• Be sureyour.a.nteana orother device i5connected properly before plugg!nq in the power cord.
[Antenna Cable Connection]
When connecting the unit to an antenna or cable TV company (without cable box)
Connect the RF coaxial cable on your home outlet to the antenna input jack of this unit
e.g.)
V HFf
antenna U
cable TV ; ;: ;
company
RF coaxial cable
rear of this ut_it
1
_Once connections are completed, turn on the unit and begin initial setup
Channel scanning is necessary for the unit to memorize all available channels in your area
(Refer to"lnitial Setup"on page 12 )
Note:
•Foryou_ safety and to avoid damage to device please unplug the RFcoaxial cable from the antenna input jack before moving tl_eunit
,If you usean antenna to receive analog TV,it should also work fat DTVreception Outdoor at attic antennas will be more effective than set-
top versions
• To easily switch your reception source between antenna and cable, install an antenna selector
, If you connect to the cable system directly, contact the CATV installer.
[Connection to Cable Box]
Connect the RF coaxial cable on your home outlet to time input jack of the cable box
Use another RF coaxial cable to connect the antenna input jack of the unit to the output jack of the cable box
e.g.)
company
rear of this unit
"Required cables and connecting methods differ depending on the cable box
Fol"more information, please contact your cable provide_
._:Z::: 9
EN