Installation Manual
Table Of Contents
- Table of Contents
- Table of Tables
- Table of Figures
- 1. About this Manual
- 2. Safety
- 3. Package Removal and Inspection
- 4. Installation
- 5. Electrical Connections
- 5.1 The Overview of Electrical Connection
- 5.2 Opening the Front Case Cover
- 5.3 The Overview of the Connection Area
- 5.4 Battery Installation
- 5.5 Inner Wiring Connection (Power and Signal Wire Connection for BMS)
- 5.6 Closing the Front Case Cover
- 5.7 A Method of Locking the Distribution Box (Board)
- 5.8 An Installation Method of Energy Meter Electrical Connection
- 5.9 A Connecting Method of the DC Line from the PV
- 6. Communication Connection
- 7. Entering Initial Installation Information
- 7.1 Information Input Administrator
- 7.2 System Information input stage
- 7.3 PC Direct Connection and Local Setting Value
- 7.4 Web Page Connection
- 8. Operation Test
- 9. Problem Confirmation
- 10. Maintenance
- 11. Technical Specifications
- 12. Disassembly
- 13. Contact
10. Maintenance
[Figure 10-2: Side cover removal]
When the side cover is removed, clean the fan by using a smooth brush, paint brush, or wet
cloth.
Remove the fan connector.
[Figure 10-3: Fan removal]
Clean the fan with a smooth brush or a wet cloth.
NOTICE
Using compressed air may damage the fan.
When cleaning the fan, do not use compressed air.
It may damage the fan.
When the fan is cleaned, assemble all the components in the in reverse order.
80 United Kingdom (Eng.) 05/2015. Rev1.1