Installation Manual
Table Of Contents
- Table of Contents
- Table of Tables
- Table of Figures
- 1. About this Manual
- 2. Safety
- 3. Package Removal and Inspection
- 4. Installation
- 5. Electrical Connections
- 5.1 The Overview of Electrical Connection
- 5.2 Opening the Front Case Cover
- 5.3 The Overview of the Connection Area
- 5.4 Battery Installation
- 5.5 Inner Wiring Connection (Power and Signal Wire Connection for BMS)
- 5.6 Closing the Front Case Cover
- 5.7 A Method of Locking the Distribution Box (Board)
- 5.8 An Installation Method of Energy Meter Electrical Connection
- 5.9 A Connecting Method of the DC Line from the PV
- 6. Communication Connection
- 7. Entering Initial Installation Information
- 7.1 Information Input Administrator
- 7.2 System Information input stage
- 7.3 PC Direct Connection and Local Setting Value
- 7.4 Web Page Connection
- 8. Operation Test
- 9. Problem Confirmation
- 10. Maintenance
- 11. Technical Specifications
- 12. Disassembly
- 13. Contact
10. Maintenance
10. Maintenance
10.1 Cleaning the Fan and the Cover
NOTICE
Qualified Person Only!
Refer to the following procedures and check the fan when error code E005 is shown. If the
fan is covered with dirty particles, clean the fan as guided in this chapter. Turn off the AC
circuit breaker and the DC disconnect switch in the distribution box, then separate the
Photovoltaic MC4 connector from the connector located on the side of the 3.6 kWh All in
One.
[Figure 10-1: PV MC4 connector]
Removal of the Photovoltaic MC4 Connector
Remove the side cover. Make sure not to remove the front case cover.
United Kingdom (Eng.) 05/2015. Rev1.1 79