Installation Manual
Table Of Contents
- Table of Contents
- Table of Tables
- Table of Figures
- 1. About this Manual
- 2. Safety
- 3. Package Removal and Inspection
- 4. Installation
- 5. Electrical Connections
- 5.1 The Overview of Electrical Connection
- 5.2 Opening the Front Case Cover
- 5.3 The Overview of the Connection Area
- 5.4 Battery Installation
- 5.5 Inner Wiring Connection (Power and Signal Wire Connection for BMS)
- 5.6 Closing the Front Case Cover
- 5.7 A Method of Locking the Distribution Box (Board)
- 5.8 An Installation Method of Energy Meter Electrical Connection
- 5.9 A Connecting Method of the DC Line from the PV
- 6. Communication Connection
- 7. Entering Initial Installation Information
- 7.1 Information Input Administrator
- 7.2 System Information input stage
- 7.3 PC Direct Connection and Local Setting Value
- 7.4 Web Page Connection
- 8. Operation Test
- 9. Problem Confirmation
- 10. Maintenance
- 11. Technical Specifications
- 12. Disassembly
- 13. Contact
7. Entering Initial Installation Information
7.3.5 Entering Setting Value
7.3.5.1 S/N
Enter shipment value from the factory (a subsequent modification is not available.)
7.3.5.2 Region
Select a city and enter the city name for installation on the menu.
7.3.5.3 PV Install Value
Enter installation capacity of each PV string.
Enter by typing by hand.
7.3.5.4 Sever IP & Port
Enter as basic value.
Perform any modification for relevant issues only.
7.3.5.5 Energy Meter Selection
Meter Type
RS485
7.3.5.6 Date/Time setting
Enter the current date and time
7.3.5.7 Save and Restart
Save onto the system after all the procedures above are completed.
7.3.5.8 Grid Feed in Limit Regulation Setting
For some countries that have a regulation for the grid feed in limit, the device allows the
installer to set up a limit value. You can select the required limit value in the [Feed in Limit
Percentage] on the set up screen. The selectable values is 0%, 60%, 70%, 80%, 90%, and
unLimited. The term unlimited means that is that there is no grid feed-in limit.
7.3.5.9 Changing the Inverter’s Output Setting
You can set maximum output value of Inverter.
It can be either 3.6 kW or 4.6 kW.
United Kingdom (Eng.) 05/2015. Rev1.1 53