Installation Manual
Table Of Contents
- Table of Contents
- Table of Tables
- Table of Figures
- 1. About this Manual
- 2. Safety
- 3. Package Removal and Inspection
- 4. Installation
- 5. Electrical Connections
- 5.1 The Overview of Electrical Connection
- 5.2 Opening the Front Case Cover
- 5.3 The Overview of the Connection Area
- 5.4 Battery Installation
- 5.5 Inner Wiring Connection (Power and Signal Wire Connection for BMS)
- 5.6 Closing the Front Case Cover
- 5.7 A Method of Locking the Distribution Box (Board)
- 5.8 An Installation Method of Energy Meter Electrical Connection
- 5.9 A Connecting Method of the DC Line from the PV
- 6. Communication Connection
- 7. Entering Initial Installation Information
- 7.1 Information Input Administrator
- 7.2 System Information input stage
- 7.3 PC Direct Connection and Local Setting Value
- 7.4 Web Page Connection
- 8. Operation Test
- 9. Problem Confirmation
- 10. Maintenance
- 11. Technical Specifications
- 12. Disassembly
- 13. Contact
7. Entering Initial Installation Information
7.3.2 Inserting Jumper Wire
[Figure 7-1: Jumper]
7.3.3 LAN Cable Connection between PC and System
7.3.3.1 LAN Cable Type
UTP cable/category 5E
1:1 direct cable
7.3.4 SIM (System Install Manager) Connection
7.3.4.1 To enable direct communication between the computer and the All in One, change
the TCP/IP settings on the computer as shown below:
Set on your laptop
[Control Panel → Network and Sharing Center → Change adapter settings → Local
Area Connector → Properties → Internet Protocol Version 4 (TCP/Ipv4)]
United Kingdom (Eng.) 05/2015. Rev1.1 51