Installation Manual
Table Of Contents
- Table of Contents
- Table of Tables
- Table of Figures
- 1. About this Manual
- 2. Safety
- 3. Package Removal and Inspection
- 4. Installation
- 5. Electrical Connections
- 5.1 The Overview of Electrical Connection
- 5.2 Opening the Front Case Cover
- 5.3 The Overview of the Connection Area
- 5.4 Battery Installation
- 5.5 Inner Wiring Connection (Power and Signal Wire Connection for BMS)
- 5.6 Closing the Front Case Cover
- 5.7 A Method of Locking the Distribution Box (Board)
- 5.8 An Installation Method of Energy Meter Electrical Connection
- 5.9 A Connecting Method of the DC Line from the PV
- 6. Communication Connection
- 7. Entering Initial Installation Information
- 7.1 Information Input Administrator
- 7.2 System Information input stage
- 7.3 PC Direct Connection and Local Setting Value
- 7.4 Web Page Connection
- 8. Operation Test
- 9. Problem Confirmation
- 10. Maintenance
- 11. Technical Specifications
- 12. Disassembly
- 13. Contact
4. Installation
(*) It can be set 3600W when installing.
[Figure 4-2: Minimum Clearance for All in One]
4.1.4 Position (Location Selection)
As shown in the [Figure 4-3], install the device on a flat surface. (Front, back, left, right
gradient within ±0.5°)
To allow for natural ventilation, the side of the system must be kept away from the wall
about 0.3m at least. Make sure not to have foreign substances and objects stuck in the
blowing fan, ventilation entrance and exit sides.
[Figure 4-3: Restriction for the surface gradient]
(* )
7
16 United Kingdom (Eng.) 05/2015. Rev1.1