Installation Manual
3
36"
countertop
height
30"
cabinet min.
28 7/16"
opening
Allow
3/16"
overlap.
Allow 3/4"
overlap.
Allow 3/4"
overlap.
4"
5"
Suggested electrical
outlet location*
Anti-Tip
block
Floor must
support
100 lbs.
14 13/16"
to bottom
of Anti-Tip
block
3 1/2"
6"
23 1/2"
min depth
19" to top of floor
(recommended)
Allow
7/16"
overlap.
14 13/16"
opening
84"
wall
cabinet
30"
cabinet min.
28 7/16"
opening
14 13/16"
opening
Allow
3/16"
overlap.
Allow
7/16"
overlap.
Allow 3/4"
overlap.
Allow 3/4"
overlap.
4"
5"
2" min.
Suggested
electrical
outlet location*
Anti-Tip
block
Optional
wall oven
cutout
illustrated
in sketch
Floor must
support
100 lbs.
14 13/16"
to bottom
of Anti-Tip
block
3 1/2"
6"
23 1/2"
min depth
19" to top of floor
(recommended)
Figure 3
Figure 4
Figures 3, 4 and 5 contain many Microwave Drawer measurements
for reference when planning the drawerโs location.
This Microwave Drawer can be installed below any electric or
gas wall oven.
* Can also be installed using an electrical outlet in an adjacent
cabinet within the area where the provided electrical cord can
30" MICROWAVE DRAWER MEASUREMENTS
NORMAL INSTALLATION STEPS
ANTI-TIP BLOCK INSTALLATION INSTRUCTIONS
To reduce the risk of tipping of the drawer, the Anti-Tip block must
be properly installed located 14 13/16-inches above the ๎oor on
which the Microwave Drawer will sit. The 6-inch Anti-Tip block
must be provided by the installer. See Figures 1 and 6 (for 24") or
Figures 3, 4 and 6 (for 30"). The Anti-Tip block prevents serious
injury that might result from spilled hot liquids.
If the Microwave Drawer is ever moved to a different location, the
Anti-Tip block must also be moved and installed. When installed
4"
15"
30"
21
5
/8"
15"
auto drawer
opening
1
3
/4"
4
11
/16"
14
19
/32"
21
7
/8"
1
11
/16"
door thickness
Figure 5
ANTI-TIP BLOCK
to the wall, make sure that the screws completely penetrate the dry
wall and are secured
in wood or metal
so that the block is
totally stable. When
fastening, be sure
that the screws do not
penetrate electrical
wiring or plumbing.
Figure 6
4"
5"
Suggested electrical
outlet location*
Anti-Tip
block
6"
3 1/2"
reach. Power cord access hole in cabinet should be a minimum
1
1
/2" diameter hole and deburred of all sharp edges.
IM PORTANT
Always allow suf๎cient power cord length to the
electrical outlet to prevent tension.
Always check electrical codes for requirements.