Installation Guide

2
21
9
/16"
21
7
/8"
14
19
/32"
1
11
/16"
door thickness
15"
23
7
/8"
15"
auto drawer
opening
1
3
/4"
4
11
/16"
4"
CLEARANCES ANd dImENSIoNS
 Dimensions that are shown in Figure 1 (for 24") or Figures
3 and 4 (for 30") must be used. Given dimensions provide
minimum clearance. Locate electrical outlet in the shaded
area in the upper left-hand corner of the cutout. See Figure 7.
 Contact surface must be solid and level. Pay special attention
totheooronwhichtheMicrowaveDrawerwillsit.The
oor of the opening should be constructed of plywood
strong enough to support the weight of the oven (about 100
pounds).
Check location where the Microwave Drawer will be
installed for proper electrical supply.
 • Your ovencanbebuiltintoacabinetorwall byitselfor
under a gas or electric wall oven.
 • Besur
ethattheclearanceoftheoorbetweenthewalloven
and the microwave drawer is a minimum of 2-inches.
 The microwave interior will easily accommodate a 9" x 13"
oblong dish or a bag of microwave popcorn.
24" mICRoWAvE dRAWER mEASUREmENtS
36"
countertop
height
24"
cabinet min.
22
1
/8"
opening
14
13
/16"
opening
Allow
7
/16"
overlap.
Allow
7
/8"
overlap.
Allow
7
/8"
overlap.
19" to top
of floor
4"
5"
Suggested electrical
outlet location*
Anti-Tip
block
Floor must
support 100 lbs.
14
13
/16"
to bottom
of Anti-Tip
block
3
1
/2"
(6")
23
1
/2"
min depth
Allow
3
/16"
overlap.


Figures 1 and 2 contain many Microwave Drawer measurements
for reference when planning the drawer’s location.
This Microwave Drawer can be installed below any electric
or gas wall oven.
* Can also be installed using an electrical outlet in an adjacent
cabinet within the area where the provided electrical cord can
reach. Power cord access hole in cabinet should be a minimum
1
1
/2" diameter hole and deburred of all sharp edges.
IM P O R TANT
Always allow sufcient power cord length to the
electrical outlet to prevent tension.
Always check electrical codes for requirements.