Manual

MICROWAVE DRAWER COOKING
MULTIPLE SEQUENCE COOKING
Your Microwave Drawer can be programmed for up to 4
automatic cooking sequences, switching from one power
level setting to another automatically.
Sometimes cooking directions tell you to start on one
power level and then change to a different power level. Your
Microwave Drawer can do this automatically.
t First enter cooking time. Then touch Power Level pad
once for 100% cooking or repeat touching Power Level pad
for a lower power level.
2 Enter second cooking time. Repeat touching Power Level
pad for desired level. You can follow this procedure up to 4
times.
3 Touch START/Minute Plus pad.
Note:
If Power Level pad is touched once, _ will be
displayed.
If 100% is selected as the final sequence, it is not necessary
to touch the Power Level pad.
Ifyou _ ish to kno_ pox_er levelduring cooking, Silnplytouch
the Power Level pad. As long as your finger is touching the
Power Level pad, the po_ er level _ill be displayed.
° Micro Warm can be programmed even if 4 cooking
sequences have been set.
HELP
Each setting of Sensor Reheat, Sensor Cook, Sensor Popcorn,
Micro Warm, Reheat and Defrost has a cooking hint. If you
wish to check, touch Custom Help whenever HELP is
lighted in the Interactive Display for these and other manual
operation hints.
MINUTE PLUS TM
Minute Plus allows you to cook for a minute at 100% by
simply touching the Minute Plus pad. You can also extend
cooking time in multiples of 1 minute by repeatedly touching
the Minute Plus pad during manual cooking.
Note:
° To use Minute Plus, touch pad x_ithin 3 minutes after
cooking, closing the door or touching the Stop/Clear pad.
° Minute Plus cannot be used _ith Sensor settings, Reheat
or Defrost.
MORE OR LESS TIME ADJUSTMENT
Should you discover that you like any of the Sensor, Reheat
or Defrost settings slightly more done, touch the Power
Level pad once after touching your selection. The display
will show _.
For slightly less done, touch the Power Level pad twice after
touching your selection. The display will show _.
AUTO START
If you wish to program the Microwave Drawer to begin
cooking automatically at a designated time of day, follow
this procedure.
1 Touch Setup/Custom Help pad 4 times. The display shows
m=c 0IIT0uc
2 Touch START/Minute Plus pad.
3 Enter start tilIte. _ _
4TouchTimor/Cloekpad
5 Touch the number pads to enter cooking time.
Touch Power Level pad repeatedly until the desired power
level is reached. _
6 Touch START/Minute Plus pad.
AUDIBLE SIGNAL ELIMINATION
If you wish to have the Microwave Drawer operate with no
audible signals, see page 25.
END OF COOKING REMINDER
At end of cooking, the Microwave Drawer will signal every
10 seconds for the first minute; then every 3minutes until the
Stop/Clear pad is touched, the Microwave Drawer is opened
or up to 1 hour. This can be canceled. See page 25.
2O