Installation guide

INSTALLATION MANUAL
The range backsplash is adjustable so that you can customize it
for your particular kitchen situation. The height can be adjusted
froln the low position (6-inches high) to the highest position
(12-inches high) in one inch increments.
Remove screw fioln the cooktop back fralne end cap on
both sides and screw from range back cover on both sides,
as shown in Figure 12.
Note: Set screws to the side to use for mounting the
backsplash. The two back plate screws must be placed back
into the back cover.
r
Parts Supplied
4 Screws
1 Backsplash 1 Rubber Gasket
I Ik_It,lq ;tl $.'I :b I
This backsplash must be installed before the range is moved
into place.
End cap
a Carefully pull each end cap back slightly--no more than
1/8-inch--to facilitate installing the backsplash.
Back cover
Figure 12
Back cover screw
No more
than t/8"
2 Slide rubber gasket on back edge of cooktop back frame as
shown in Figure 13.
Rubber
Gasket
Cooktop Back
Frame
4 Slide backsplash in to desired height. Secure into position
with screws supplied and those removed in step 1.
Figure 13 Figure 14
6