Installation guide

ManualsBrandsSharp ManualsOtherKB-3300JS

INSTALLATION MANUAL

208/240 VOLT CONNECTION INSTRUCTIONS

The range can be set for 208V o1"240V. The voltage setting for your

range is pre-set at 240V from the factory. Follow these steps to

change the voltage setting.

t Locate the voltage switch on the lower back side of the

range.

2 Remove the screw and rotate the switch plate 180° as indicated

in the Figure 3.

a Reinsert the switch plate and replace screw as indicated

in Figure 4. The voltage setting is indicated by the visible

marking.

screw

Figure 3 Figure 4

3 & 4-WIRE ELECTRICAL WALL RECEPTACLE TYPES &

RECOMMENDED MOUNTING ORIENTATION ON WALL

Figure 5A illustrates 4-wire receptacle required for new and

remodeled installations.

Figure 5B illustrates 3-wire receptacle that is allowed for existing

installations.

4-wire walt receptacle (14-50R)

Figure 5A

3-wire wall receptacle (10-50R)

Figure 5B

ACCESS TO TERMINAL BLOCK

Loosen screw on rear access cover and pull down as illustrated in

Figttre 6 to access terminal block wiring connection. To close, retm'n

to original location and secure screw.

strain relief clamp

Figure 6 Figure 7

4-WIRE CONNECTION INSTRUCTIONS-FIGURE 8

Before wiring the range, review the suggested power source location

drawing in Figure 2. If connecting to a 4-wire electrical system for a

new branch-circuit or mobile home use a 4-wire connection.

1 Follow the power supply kit manufacturer's Installation

Instructions supplied with the strain relief clamp and install.

See Figure 7.

2 Insert the end connectors for line 1, line 2 and neutral and

tighten securely to the terminal block.

DO NOT LOOSEN the factory installed nut

connections which secure the range wiring to the terminal

block. Electrical failure or loss of electrical connection may

occur if these 3 nuts are loosened or removed.

3 You must disconnect the ground strap. Remove the factory

installed ground screw and plate to release the copper ground

strap from the frame of the range. Cut and discard the copper

ground strap and plate. KEEP the ground screw.

4 Connect the green ground wire lead with the eyelet to the frame

of the range with the ground screw using the same hole in the

frame where the ground screw was originally installed. See

Figure 8.

5 Make sure all screws are tightened securely and replace the

rear access cover. See Figure 6.

3-WIRE CONNECTION INSTRUCTIONS

For existing installations ONLY, refer to Figure 9.